Wire Adjustment - Markusson combiMatic User Manual

WIRE ADJUSTMENT

For the grinding machine to function properly, it is important that the wire is adjusted
correct. It is set in factory but will be worn over time making adjustment or replacement
necessary. To adjust the wire correct, follow these steps:
NOTE! The machine is to be set at high speed (rabbit) when adjusting the wire.
1. Start by turning the grinding
head to the left.
3. Turn the machine and have a look 4. The lifting arm (1) shall meet the
At the back. Start the machine and flange (2) app. 1,5 sec before
observe as the lifting arm (1)
meets the flange (2).
2. Set the angle to 30
NOTE: Head to the left.
lifting again. Use a 0,05 mm feeler gauge
between the arm and the flange to control
that contact is made.
Pictures (step 3 & 4), see next page.
12
°.