Table of Contents
Advertisement
POWER SUPPLY
For the best performance, the machine should be connected to the Markusson
Converter. The machine can also be powered from a 12-volt car battery or from
a battery charger with an output of 12 – 15 volts DC (min 10 ampere). When
using a battery, connect the red cable to the positive terminal (+) and the black
one to the negative (-).
If the cables are connected to the wrong terminals, the grinding disc and the
feeder motor will turn in wrong direction, causing the machine to break
down. Compare the direction of rotation with the arrow on the cover.
NOTE:
Position the battery, battery charger or power converter where
there is as little dust as possible. Make sure that the battery terminals are
connected to the correct poles of the battery. Position the battery so that
sparks from the sharpening machine cannot reach it.
ACCESSORIES
Besides the machine, there are a number of accessories in the kit:
1. Grinding disc guard
2. Torx sheet metal screw x2
3. Grinding disc 150x4x16
4. Grinding disc 150x6x16
5. Grinding disc 150x10x16
When machine is delivered with a stand, the following are also supplied:
11. M6 nut x2 (stand) 12. M6 Screw x2 13.Carrigebolt M6 x2
6. Profile stone
7. Profile template
8. Allen key
9. Chain feeder
10. Spacers x4, for chain ruler
5
Advertisement
Table of Contents
