Table of Contents
Advertisement
TRIAL SHARPENING
Test the various functions of the machine and study the motions.Always stop the machine
when the grinding head reaches itsuppermost position. The chain rulers are then
"unlocked" and thechain is free. When you have done a trial run with the machine and
feel familiar with it, you can put in a chain. Now test-sharpen a chain,
following the instructions in under Sharpening cutting links.
In the interest of safety, use an old chain.
SHARPENING CUTTING LINKS
To sharpen a chain in the Combimatic machine, proceed with these steps:
(Numbers correspond to parts shown on page 17)
1. Activate power (Power in) - 8
2. Start grinding motor - 1
3. Profile the disc – see picture below
4. Turn grinding motor off - 1
Place the chain to be sharpened between chain rulers 5.
Pull the chain around by hand and check that it runs freely in the chain rulers
Check also whether the chain has "double links", that it does not have any burrs
on the drive links and that it is not damaged.
NOTE: If there are double links, see the instructions for double links.
Always use safety gloves when handling saw chains.
Risk of cutting injury.
16
Advertisement
Table of Contents
