Table of Contents
Advertisement
OPERATION STAND & TENSIONER
NOTE! Keep hand, fingers and other body parts away from area behind the protective
plastic sheet – Crushing Hazard
Positions chain (1) placing it below the tensioner roll (2) by lifting the tensioner arm (3). If
necessary, loosen handle (7) and move the tensioner upwards . There should be a gap of
about 10-15mm between the nut (4) and cylinder (5) (10-15mm of the piston should be
visible). Tighten locking handle (7) again.
If the next chain to be sharpened has the same length, You will only need to lift the arm
(3) when replacing chain.
NOTE! In case of emergency – loosen locking handle (7) to release tension and eliminate
crushing hazard.
Always turn power off!
Crushing hazard!
18
Advertisement
Table of Contents
