Lockout/Tagout Procedure; Safety Considerations; Safety Hazards; Electrical Hazards - Wine Guardian D050 Installation, Operation And Maintenance Manual

Following is a typical example of a Caution message as it could appear in the manual:
Improper installation may result in the equipment malfunctioning and a safety hazard.
Read all of the installation instructions before installing the Wine Guardian unit.

Lockout/Tagout Procedure

1. Turn off the power switch (indicator light should be off)
2. Unplug the unit from the electrical outlet and cover the outlet to prevent
accidently plugging in the unit.

Safety Considerations

The equipment covered by this manual is designed for safe and reliable operation when installed and
operated within its designed specifications. To avoid personal injury or damage to equipment or
property when installing or operating this equipment, it is essential that qualified, experienced
personnel perform these functions, using good judgment and safe practices. See the following
cautionary statements.
Installation and maintenance of this equipment is to be performed only by qualified personnel who
are familiar with local codes and regulations, and are experienced with this type of equipment.

Safety Hazards

Exposure to safety hazards is limited to maintenance personnel working in and around the unit.
When performing maintenance, always use the Lockout/Tagout procedure, which is described in this
chapter. Observe the maintenance safety guideline in the Wine Guardian Manual.

Electrical Hazards

Working on the equipment may involve exposure to dangerously high voltage. Make sure you are
aware of the level of electrical hazard when working on the system. Observe all electrical warning
labels on the unit.

Electrical Shock Hazards

All power must be disconnected prior to installation and servicing this equipment. More than one
source of power may be present. Disconnect all power sources to avoid electrocution or shock
injuries.

Hot Parts Hazards

Electric resistance heating elements must be disconnected prior to servicing. Electric heaters may
start automatically, disconnect all power and control circuits prior to servicing the unit to avoid
burns.
CAUTION
RISK OF PERSONAL INJURY OR DAMAGE TO EQUIPMENT
21