Table of Contents
Advertisement
C–54
Picture 74
SCAN menu
5 s
10 s
15 s
20 s
25 s
∞
Pi t
74
Pushing the button SCAN located in cluster FUNCTION will activate scanning
of channels which are earmarked for scanning (see page C33). The receiver
will scan any frequency between 9 kHz and 29.999 MHz, and it will scan
frequencies from 50.0 to 54.0 MHz and 144.0 to 148.0 MHz.
These frequencies will be checked for a signal.
The RX will scan the channels from lower to higher frequencies with the
stored MODE and bandwidth.
•
•
•
Pushing SCAN will:
•
•
•
Delay time is 5 seconds
Delay time is 10 seconds
Delay time is 15 seconds
Delay time is 20 seconds
Delay time is 25 seconds
Delay time is infinite
Scanning will be terminated upon activating PTT, VFO tuning, STEP-VFO or
pushing SCAN. The frequency of the stanby VFO will reappear.
Part C Installation And Operation
If the squelch is engaged scanning will Stopp
when a signal on a scanned channel opens the
squelch
If the squelch is open, the RX will pause on the
scanned frequency for a time defined. After this
time has elapsed the scanning will continue.
If the squelch engages during the pause
scanning will continue immediately
SCAN-LED will be on
The
frequency
of
the
disappear.
Instead
information
scanned channel is displayed as in channel
modus (see page C33)
SCAN softkey menu will be called up
standby
VFO
will
about
the
Advertisement
Table of Contents
