Main Tunung Knob - Hilberling PT-8000 Operating Manual

C–38
11.4 MAIN Tuning Knob
VFO menu
Picture 43
Example
VFO frequency displayed
1.234.567
1st pushing STEP up
1.234.56
2nd pushing STEP up
1.234.5
3rd pushing STEP up
1.234
Primary means of tuning the active RX (Main- or SUB-RX) is the main tuning
knob.
General frequency coverage is 9 kHz to 54 MHz and 110 MHz to 170 MHz.
Due to the frequency scheme of the PT-8000 the frequency from 54 MHz to
110 MHz is blanked out.
Transmit operation is only possible on the allocated amateur radio bands (see
Tab on page C20)
In case the transmit boundaries are to be modified (commercial application;
new amateur radio frequencies) please contact Hilberling GmbH for further
information about a software update.
The tuning increments are adjustable through STEP selection, which is
allocated to the VFO soft key menu.
STEP up (towards fine tuning) decreases the tuning increments by power of
10. Additional digits appear at the VFO frequency readout
STEP down (towards coarse tuning) increases the tuning increments by
power of 10. Lesser digits appear at the VFO frequency readout
The selectable increments are 1 Hz / 10 Hz / 100 Hz / 1 kHz.
Not displayed digits are set to 0.
Transceiver-Frequency
Part C Installation And Operation
1.234,567 kHz 1 Hz increments
1.234,560 kHz 10 Hz increments
1.234,500 kHz 100 Hz increments
1.234,000 kHz 1 kHz increments
Tuning with
Table 12