C–40
11.6 VFO Management
Picture 46
Picture 47
Both receivers (MAIN- and SUB-RX) have its own VFOs – VFO A
and VFO B. Switching between VFO A and VFO B is established
through VFO A/B pushbutton. The button is located in the cluster
VFO.
In addition to the frequencies the VFOs store the filter
(bandwidth) and mode information.
When pressing VFO A/B:
•
•
•
Both frequencies displayed for the active RX will alter its
position. The white display always shows the selected
VFO. The VFO can be identified through the red
nominators A/B.
•
The smaller green display always shows the alternate
VFO that is not selected and in red its identifier.
Only the SUB-RXs selected VFO frequency is displayed without its identifier.
Active RX
(shown MAIN-RX)
selected VFO (shown VFO A)
Part C Installation And Operation
In case the VFO softkey menu is already
displayed the respective RX will change its VFO
(A=>B or B=>A).
If a different softkey menu is displayed the first
push of VFO A/B will call up the VFO softkey
menu. The second push will alter the VFO A an
VFO B.
RX in background
(shown SUB-RX)
Frequency of selected VFO
Picture 48