Table of Contents
Advertisement
C–26
AM menu
Picture 30
FM menu
Picture 31
How to set the repeater frequency shift
Pressing AM / FM will place the PT-8000 in AM/FM mode whatever has been
the last mode. If the mode is already AM or FM the alternate mode will be
activated.
The according soft key menu (AM or FM) will be called up.
Amplitude Modulation (carrier and two sidebands)
AM Synchronous (carrier and Lower Sideband)
AM Synchronous (carrier and Upper Sideband)
AM single sideband (AME – AM Equivalent) (carrier and Lower Sideband)
AM single sideband (AME – AM Equivalent) (carrier and Upper Sideband
Cyclic
change
→
→
1
Hz
Frequency Modulation (standard mode)
FM repeater mode. The transmit frequency is lower than the receive
frequency (standard). Frequency shift default value is 600 kHz
FM repeater mode. The transmit frequency is higher than the receive
frequency (inverse). Frequency shift default value is 600 kHz
Press and hold to monitor the transmit frequency – squelch is
deactivated
;
(Only available if repeater mode is selected)
Press to set the frequency shift for repeater mode (see note below)
Cyclic
change
→
→
1
Hz
Part C Installation And Operation
of
frequency
→
10
Hz
100
Hz
RX
RPT
is
of
frequency
→
10
Hz
100
Hz
tuning
steps:
→
→
1
kHz
displayed
inverse.
tuning
steps:
→
→
1
kHz
Advertisement
Table of Contents
