Table of Contents
Advertisement
Section 1 Overview ........................................................................................... 1
1.1
Environment Conditions ...................................................................................................1
1.2
Supported MCUs and User System Interface Cables........................................................2
1.3
Operating Voltage and Frequency Specifications .............................................................3
Section 2 User System Interface ....................................................................... 5
2.1
Signal Protection ...............................................................................................................5
2.2
User System Interface Circuits..........................................................................................5
Section 3 Notes on Use ..................................................................................... 9
3.1
I/O Register Differences between Actual MCU and E6000..............................................9
3.2
Access to the Reserved Area .............................................................................................9
3.3
Use of an Internal RAM Area as External Memory..........................................................10
3.4
Support of Flash Memory .................................................................................................10
3.5
Hardware Standby .............................................................................................................10
3.6
EXDMA controller............................................................................................................10
3.7
SIMM Memory Module Access........................................................................................10
3.8
Power Supply Follower Circuit.........................................................................................10
Section 4 HDI Parameters ................................................................................. 11
4.1
Address Areas ...................................................................................................................11
4.2
Access Status.....................................................................................................................12
4.3
IRQ Signal Trace...............................................................................................................12
Section 5 Diagnostic Test Procedure ................................................................ 13
5.1
System Set-Up for Test Program Execution .....................................................................13
5.2
Diagnostic Test Procedure Using the Test Program..........................................................14
ii
Contents
Advertisement
Table of Contents
