Wireless Access - LevelOne NetCon WBR-3408 User Manual

11g wireless broadband router
Hide thumbs Also See for NetCon WBR-3408:
Table of Contents

Advertisement

Appendix A - Troubleshooting
Problem 2:
Some applications do not run properly when using the Wireless
Router.
Solution 2:
The Wireless Router processes the data passing through it, so it is
not transparent.
For incoming connections, you must use the Virtual Server or Firewall
Rules to specify the PC which will receive the incoming traffic.
You can also use the DMZ function. This should work with almost
every application, but:

Wireless Access

Problem 1:
My PC can't locate the Wireless Access Point.
Check the following.
Solution 1:
It is a security risk, since the firewall is disabled.
Only one (1) PC can use this feature.
Your PC is set to Infrastructure Mode. (Access Points are always
in Infrastructure Mode)
The SSID on your PC and the Wireless Access Point are the
same.
Remember that the SSID is case-sensitive. So, for example
"Workgroup" does NOT match "workgroup".
Both your PC and the Wireless Router must have the same
setting for WEP. The default setting for the Wireless Router is
disabled, so your wireless station should also have WEP dis-
abled.
If WEP is enabled on the Wireless Router, your PC must have
WEP enabled, and the key must match.
If the Wireless Router's Wireless screen is set to Allow Trusted
PCs only, then each of your Wireless stations must have been
designated as "Trusted", or the Wireless station will be blocked.
To see if radio interference is causing a problem, see if connec-
tion is possible when close to the Wireless Router.
Remember that the connection range can be as little as 100 feet
in poor environments.
106

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NetCon WBR-3408 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Wbr-3408

Table of Contents