Wireless Hart Data - Endress+Hauser Micropilot FMR60B Technical Information

Micropilot FMR60B HART

Wireless HART data

Endress+Hauser
Device type ID:
0x11C1
Device revision:
1
HART specification:
7
DD version:
1
Device description files (DTM, DD)
Information and files under:
• www.endress.com
On the product page for the device: Documents/Software → Device drivers
• www.fieldcommgroup.org
HART load:
Min. 250 Ω
HART device variables
The following measured values are assigned to the device variables at the factory:
Device variable
1)
Assign PV
Assign SV
Assign TV
Assign QV
1) The PV is always applied to the current output.
Choice of HART device variables
• Level linearized
• Distance
• Terminal voltage
• Electronics temperature
• Sensor temperature
• Absolute echo amplitude
• Relative echo amplitude
• Area of incoupling
• Build-up index
• Build-up detected
• Foam index
• Foam detected
• Percent of range
• Loop current
• Terminal current
• Not used
Supported functions
• Burst mode
• Additional transmitter status
• Device locking
Minimum start-up voltage:
10.5 V
Start-up current:
< 3.6 mA
Starting time:
< 15 s
Minimum operating voltage:
10.5 V
Measured value
Level linearized
Distance
Absolute echo amplitude
Relative echo amplitude
13