CHAINTECH CT-5SSV Manual page 38

User's Manual
I. Standby Mode
The Power Management function must not be set to disabled to enable this
function. If the system runs in Doze mode and the Standby timer expires, the
system will enter Standby mode. In Standby mode, the hard disk drive and the
monitor shut off while all other devices still operate at full speed. Note that the
Video Off and HDD Power Down functions in Figure 3-5 provide the same power
saving options found in Standby mode. The priority for determining which
function controls power saving for the monitor and hard drive is determined by
which timer expires first.
J. Suspend Mode
The Power Management function must not be set to disabled to enable this
function. If the system runs in Standby mode and the Suspend timer expires, all
devices regulated by power management will shut off and the CPU speed will be
0 MHz.
K. PM Events
The HDD/COM/LPT/VGA Acitvity and IRQ[3-7,9-15], NMI. When Enabled any
activity from one of the listed system peripheral or devices, IRQs wakes up the
system.
A power-management (PM) event awakens the system from, or resets activity
timers for, Suspend mode. You can disable monitoring of common interrupt
requests so they do not generate PM events.
L. IRQ8 Break Suspend
Enabling this setting turns the monitoring of IRQ8 (the Real Time Clock) On so
it does not awaken the system from Suspend mode.
M. Power Button Over Ride
When set to Delay 4 Sec., this function allows the power button to put the system
in Suspend, a power saving mode. See Section 2-4 for operation instructions of
the over-ride power button operation wich puts the system in Suspend mode.
When set to Instant-Off the Power Button Over Ride function is disabled and
the computer turns completely off when the power button is pressed.
N. Wake Up On LAN
Enable this selection to use the Wake Up On LAN function discussed in Section
2-4 of this manual.
34