CHAINTECH CT-5SSV Manual page 21

WOL (Wake-on-LAN) Connector (J4)
1
1
1
1
1
1
Clear CMOS Data Jumper (JP12)
1
1
1
1
1
1
Enable the Wake Up On LAN selection in BIOS's
Power Management Menu to use this function. The
capability to remotely manage PCs on a network is a
significant factor in reducing administrative and
ownership costs. Magic Packet technology is
designed to give WOL (Wake-on-LAN) capability to
the LAN controller. When a PC capable of receiving
wake up command goes to sleep, the Magic Packet
mode in the LAN controller is enabled. When the
LAN controller receives a Magic Packet frame, the
LAN controller will wake up the PC. This header is
used to connect an add-in NIC (Network Interface
Card) which gives WOL capability to the mainboard.
To support this function, a switching power
supply with a minimum of 750mA 5VSB is
required.
1
Normal (default)
To clear the contents of the CMOS, please follow the
steps below.
1. Disconnect the system power supply from the power
source.
2. Set the jumper cap at location 2~3 for 5 seconds, then
set it back to the default position.
3. Connect the system's power and then start the system.
4. Enter BIOS's CMOS Setup Utility and choose Load
Setup Defaults. Type Y and press enter.
5. Set the system configuration in the Standard CMOS
Setup menu.
Hardware Setup
1
Clear CMOS data
17