CHAINTECH CT-5SSV Manual page 17

Front Panel Connector Set (J5) A through G
1
1
1
1
1
1
1
Over-ride Power Button Over-ride Power Button Over-ride Power Button Over-ride Power Button Over-ride Power Button
O p e r a t i o n O p e r a t i o n O p e r a t i o n
O p e r a t i o n O p e r a t i o n
Blinking LED in Suspend Mode(optional)
While in Suspend mode, the LED light on the front panel of your computer will flash.
Suspend mode is entered by pressing the Override Power Button, pushing the Green
button on your ATX case, or enabling the Power Management and Suspend Mode
options in BIOS's Power Management menu. (See section 3-4)
A. Over-ride Power Button Connector
The power button on the ATX chassis can be used as a
normal power switch as well as a button to activate Advanced
Power Management Suspend mode. This mode is used for
saving electricity when the computer is not in use for long
periods of time. The Power Button Over Ride function in
BIOS's Power Management Setup menu must be set to
"Delay 4 Sec." to activate this function. (See section 3-4)
When the Power Button Over Ride function is enabled,
pushing the power button rapidly will switch the system to
Suspend mode. Any occurence of external activity such as
pressing a key on the keyboard or moving the mouse will
bring the system back to Full-On. Pushing the button while
in Full-On mode for more than 4 seconds will switch the
system completely off. See Over-ride Power Button
Operation diagram.
B. Keyboard Lock & Power Indicator LED
Connector
Plugging this connector into the lock on the front panel
of the system case allows the lock to enable or disable
the keyboard. This function provides limited security
against casual intruders. The power indicator LED shows
the system's power status. It is important to pay attention
to the correct cable and pin orientation (i.e., not to reverse
the order of these two connectors.)
Power Good LED
Keyboard Lock
Pin Definition
1 +5V DC
2 No Connect
3 Ground
4 Keylock
5 Ground
Hardware Setup
13