MEMS Digital Portable Horizontal Inclinometer
V1.1
09/02/2022
with the goods as detailed above. You will then be contacted and informed whether
your warranty claim has been validated.
14.2. Packaging and Carriage
All used goods shipped to the factory must be sealed inside a clean plastic bag and
packed in a suitable carton. If the original packaging is not available, Geosense®
should be contacted for advice. Geosense® will not be responsible for damage
resulting from inadequate returns packaging or contamination, under any
circumstances.
14.3. Transport & Storage
All goods should be adequately packaged to prevent damage in transit or
intermediate storage.
15. LIMITED WARRANTY
The manufacturer, (Geosense Ltd), warrants the MEMS Digital Portable Inclinometer
manufactured by it, under normal use and service, to be free from defects in material and
workmanship under the following terms and conditions:
Sufficient site data has been provided to Geosense® by the purchaser as regards the nature
of the installation to allow Geosense® to select the correct type and range of MEMS Digital
Inclinometer and other component parts.
The MEMS Digital Portable Inclinometer equipment shall be installed in accordance with the
manufacturer's recommendations.
The equipment is warranted for 2 years from the date of shipment from the
manufacturer to the purchaser.
The warranty is limited to replacement of part or parts which are determined to be
defective upon inspection at the factory. Shipment of defective part or parts to the
factory shall be at the expense of the Purchaser. Return shipment of repaired /
replaced part or parts covered by this warranty shall be at the expense of the
Manufacturer.
Unauthorised alteration and/or repair by anyone which, causes failure of the unit or
associated components will void this LIMITED WARRANTY in its entirety.
The Purchaser warrants through the purchase of the MEMS Digital Inclinometer
equipment that he is familiar with the equipment and its proper use. In no event shall
the manufacturer be liable for any injury, loss or damage, direct or consequential,
special, incidental, indirect or punitive, arising out of the use of or inability to use the
equipment sold to the Purchaser by the Manufacturer.
67
Need help?
Do you have a question about the MEMS DPI I and is the answer not in the manual?