Checking Engine Start System - Kubota B1620 Operator's Manual

(1) Grease fitting (Top link)
(2) Grease fitting (Lifting rod, right)
(1) Grease fitting (Parking brake)
(1) Parking brake (A) Greasing
BChecking Engine Start System
To avoid personal injury:
A Do not allow anyone near the tractor while
testing.
A If the tractor does not pass the test do not
operate the tractor.
C Preparation before testing.
1. Sit on operator's seat.
2. Set the parking brake and stop the engine.
3. Shift the main gear shift lever in "NEUTRAL" position.
4. Shift the PTO gear shift lever to "NEUTRAL" position.
5. Fully depress the clutch pedal.
C Test : Switch for the main gear shift lever.
1. Fully depress the clutch pedal.
2. Shift the main gear shift lever to "Desired" position.
3. Turn the key to "START" position.
4. The engine must not crank.
C Test : Switch for the PTO gear shift lever.
1. Fully depress the clutch pedal.
2. Shift the main gear shift lever to "NEUTRAL" position.
3. Shift the PTO gear shift lever to "ON" (Engaged)
position.
4. Turn the key to "START" position.
5. The engine must not crank.
C Test : Switch for the Operator's seat.
1. Sit on operator's seat.
2. Start the engine.
3. Fully depress the clutch pedal.
4. Shift the PTO gear shift lever to "ON" (Engaged)
position.
5. Release the parking brake.
6. Stand up. (Do not get off the tractor.)
7. The engine must shut off after approximately 1
second.
8. If it does not stop, consult your local KUBOTA Dealer
for this service.
A If the engine cranks during any of these tests, consult
your local KUBOTA Dealer to have unit checked
before operating.
PERIODIC SERVICE 53