Table of Contents
Advertisement
BChecking Parking Brake
Pull the parking brake lever to apply the brakes. With the
key switch at "ON" position, the parking brake indicator on
the instrument panel lights up.
To release the brakes, push in the button at the tip of the
parking brake lever and tilt down the lever.
A Make sure the (
) lamp on the instrument panel goes
off when parking brake lever is down.
(1) Parking brake lever
(2) Release button
BChecking Gauges, Meter and Easy
Checker (TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker (TM).
2. Replace if broken.
BChecking Head Light, Hazard Light etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
BChecking Seat Belt
1. Always check condition of seat belt attaching
hardware before operating tractor.
2. Replace if damaged.
BChecking Movable Parts
If any of the movable parts, such as levers and pedals, is
not smoothly moved because of rust or sticky material, do
not attempt to force it into motion.
In the above case, remove the rust or the sticky material,
and apply oil or grease on the relevant spot.
Otherwise, the machine may get damaged.
(A) "PULL"
(B) "RELEASE"
EVERY 50 HOURS
BChecking Engine Start System
To avoid personal injury or death:
A Do not allow anyone near the tractor while
testing.
A If the tractor does not pass the test, do not
operate the tractor.
C Preparation before testing.
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
C Test: Switch for the main gear shift lever.
1. Follow the instruction of "PARKING THE TRACTOR".
(See
"PARKING
THE
OPERATION" section.)
2. Sit on the operator's seat.
3. Shift the main gear shift lever to the desired position.
4. Depress the clutch pedal fully.
5. Disengage the PTO clutch control switch or lever.
6. Turn the key to "START" position.
7. The engine must not crank.
8. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test: Switch for the PTO clutch control switch or
lever.
1. Follow the instruction of "PARKING THE TRACTOR".
(See
"PARKING
THE
OPERATION" section.)
2. Sit on the operator's seat.
3. Engage the PTO clutch control switch or lever.
4. Depress the clutch pedal fully.
5. Shift the main gear shift lever to the neutral position.
6. Turn the key to "START" position.
7. The engine must not crank.
8. If it cranks, consult your local KUBOTA Dealer for this
service.
C Test: Checking Operator Presence Control
(O.P.C.) System.
1. Follow the instruction of "PARKING THE TRACTOR".
(See
"PARKING
THE
OPERATION" section.)
2. Make sure the PTO drive shaft is disconnected from
the tractor.
3. Sit on the operator's seat.
4. Start the engine.
5. Engage the PTO clutch control switch or lever. The
PTO should begin to rotate. Disengage the PTO clutch
control switch or lever.
6. While lifting yourself from the seat, engage the PTO
clutch control switch or lever.
(1) The PTO should begin to rotate and a buzzer
should sound.
(2) Disengage the PTO clutch control switch or lever.
PERIODIC SERVICE
TRACTOR"
in
"SAFE
TRACTOR"
in
"SAFE
TRACTOR"
in
"SAFE
77
Advertisement
Table of Contents
