Fieldmann FZK 70305-0 User Manual page 12

EN EN 12 12
Assembly
6. Fit a wheel cover (G) onto the wheel (F) and clip it into place. You must line up the tabs on the wheel cover
into the slots on the wheel.
7. Do this for both wheels.
STEP 2: Attach The Wheels
1. Place the spacer (P) onto the bolt (O). Then insert the bolt through the hole on the wheel axle bracket (H1).
Make sure the washer fits inside the hole as shown.
2. Right-hand side (opposite the wheel height adjuster pin) - Place the washer (S) onto the bolt
(O) before inserting the bolt through the hole on the lower handlebar.
Left-hand side (next to the wheel height adjuster pin) - There is no need to add a washer to this
side. Push the bolt through the hole on the lower handlebar.
FZK 70305-0