Mellanox Technologies SwitchX-2 MSX6018F-1SFS Hardware User Manual page 52

Rev 1.1
Issue 8.
Issue 9.
52 Mellanox Technologies
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
If the switch comes on, Use the MLNX-OS® management CLI or Web GUI to
5.
determine the cause of the Shutdown.
Check the temperature.
6.
Check the Fan status.
7.
The switch is not working and unresponsive:
Reset the switch.
1.
If resetting the switch does not work:
Unplug the switch.
1.
Wait 5 minutes.
2.
Plug in the switch.
3.
If the switch does not come on, check the power supplies.
4.
If the switch comes on, use the MLNX-OS® management CLI or Web GUI to
5.
determine the cause of the shutdown.
The last software update did not succeed:
Connect the RS232 connector (CONSOLE) to a laptop.
1.
Push the reset button on the switch or management module.
2.
You will have ~ 5 seconds to stop the U-Boot by pressing Control-B.
3.
Choose the image to upload. Only use image 1 or image 2.
4.
U-Boot 2009.01-mlnx1.4 (<date>)
CPU: AMCC PowerPC 460EX Rev. A at 1000 MHz (PLB=200, OPB=100, EBC=100 MHz)
Security/Kasumi support
Bootstrap Option H - Boot ROM Location I2C (Addr 0x52)
Internal PCI arbiter disabled
32 kB I-Cache 32 kB D-Cache
Board: Mellanox PPC460EX Board
FDEF: No
I2C: ready
DRAM: 2 GB (ECC enabled, 400 MHz, CL3)
FLASH: 16 MB
NAND: 1024 MiB
PCI: Bus Dev VenId DevId Class Int
PCIE0: link is not up.
PCIE1: successfully set as root-complex
01 00 15b3 bd34 0c06 00
Net: ppc_4xx_eth0, ppc_4xx_eth1
Hit Ctrl+B to stop autoboot: 0
Mellanox MLNX-OS
Boot Menu:
1. SX_PPC_M460EX 3.2.0000-dev-HA 2013-04-10 12:02:49 ppc
Troubleshooting