General - GE MAC 5500 Service Manual

General

1-6
Introduction: Safety Messages
The intended use of this device is to record ECG signals from surface ECG
electrodes. This device can analyze, record, and store electrocardiographic
information from adult and pediatric populations. This data can then be computer
analyzed with various algorithms such as interpretive ECG and signal averaging for
presentation to the user.
This device is intended for use under the direct supervision of a licensed health care
practitioner.
Failure on the part of the responsible individual, hospital, or institution using this
equipment to implement a satisfactory maintenance schedule may cause undue
equipment failure and possible health hazards.
To ensure patient safety, use only parts and accessories manufactured or
recommended by GE Medical Systems Information Technologies.
Contact GE Medical Systems Information Technologies for information before
connecting any devices to this equipment that are not recommended in this manual.
If the installation of this equipment, in the USA, will use 240 V rather than 120 V,
the source must be a center-tapped, 240 V, single-phase circuit.
Parts and accessories used must meet the requirements of the applicable IEC 60601
series safety standards, and/or the system configuration must meet the requirements
of the IEC 60601-1-1 medical electrical systems standard.
The use of ACCESSORY equipment not complying with the equivalent safety
requirements of this equipment may lead to a reduced level of safety of the resulting
system. Consideration relating to the choice shall include:

use of the accessory in the PATIENT VICINITY; and
 evidence that the safety certification of the ACCESSORY has been
performed in accordance to the appropriate IEC 60601-1 and/or IEC
60601-1-1 harmonized national standard.
MAC 5500 resting ECG analysis system
2020299-020
Revision E