With Telnet - Agilent Technologies InfinityLab 1290 Infinity II User Manual

3 LAN Configuration
TCP/IP Parameter Configuration

With Telnet

Whenever a TCP/IP connection to the module is possible (TCP/IP parameters set
by any method), the parameters may be altered by opening a Telnet session.
1 Open the system (DOS) prompt window by clicking the Windows Start button
2 Type the following into the RUN dialog box:
If Telnet is not installed on your PC by default, you can turn on the feature via
NOTE
Windows Control Panel.
Agilent InfinityLab ELSD User Manual
and select Run....
OR
Press the Windows button and R simultaneously, and click OK.
•
Telnet <IP Address>
• Telnet <host name> _ this can be set manually.
Figure 5 Starting a Telnet session
Where <IP address> may be the assigned address via the instrument, a
configuration session using the Web interface of the default IP address
(see Table 8 on page 29).
When the connection is established successfully, the module responds with
the following:
Figure 6 A connection to the module is made
33