Ford ENDURA 2017 Owner's Manual page 255

WARNINGS
Never place anything between the
vehicle jack and your vehicle.
Note: Passengers should not remain in your
vehicle when the vehicle is being jacked.
1. Park on a level surface, set the parking
brake and activate the hazard flashers.
2. Place the transmission in park (P) and
turn the engine off.
E175447
3. Block both the front and rear of the
wheel diagonally opposite the flat tire.
For example, if the left front tire is flat,
block the right rear wheel.
4. Lift and remove the carpeted load floor
panel to access the minispare and jack
kit.
5. Remove the steel winged washer nut
securing the spare tire by turning it
counterclockwise.
6. Remove the spare tire from the spare
tire compartment.
7. Remove plastic wing nut and jack and
lug wrench assembly. Detach lug
wrench from jack by turning the jack
hex nut drive screw counterclockwise.
8. Loosen each wheel lug nut one-half
turn counterclockwise, but do not
remove them until the wheel is raised
off the ground.
Endura (CDQ) New Zealand, enNZL, Edition date: 201712, First Printing
Wheels and Tires
E242877
9. The vehicle jacking points are depicted
E201100
10.
11.
252
by arrows on the underside of the
vehicle at the locations shown above.
Find the arrows embossed on the
vehicle downward flange next to the
tire you are changing.Position the jack
so that the vehicle downward flange
rests in the jack saddle flange
between the arrows, as shown
above. Raise the vehicle by using the
lug wrench to turn the jack nut
clockwise. Once the flat tire is raised
above the ground, remove the lug
nuts with the lug wrench.
Replace the flat tire with the spare
tire, making sure the valve stem is
facing outward. Reinstall the lug nuts
until the wheel is snug against the
hub. Do not fully tighten the lug nuts
until the wheel has been lowered.