Ford ENDURA 2017 Owner's Manual page 179

Using the Intelligent Speed Limiter
(If Equipped)
WARNING
The system is designed to aid the
driver. It is not intended to replace
your attention and judgment. You are
still responsible to drive with due care and
attention.
Note: When driving between countries that
use different units of measure (miles per
hour or kilometers per hour), there may be
a delay before the system changes between
speed limit units. During this time, the
display screen for the speed limiter may
differ from the actual posted speed limit.
For best performance, make sure that the
navigation SD card is in the navigation
media port.
The system allows you to automatically
limit your vehicle speed to the speed limit
that is detected by the Traffic Sign
Recognition system.
You can change the speed limiter mode
between manual and intelligent in the
information display. See General
Information (page 76).
You can select a permanent set speed
tolerance that is in addition to the detected
speed limit through the tolerance menu in
the information display. See General
Information (page 76).
Switching the System On and Off
Press LIM CNCL/OFF to set the limiter in
standby mode. The information display
will prompt you to set a speed or show the
detected speed limit as the set speed. The
Intelligent Speed Limiter will not limit the
vehicle speed in standby mode. The Auto
LIM symbol and set speed indication show
as grey in standby mode. Press LIM
CNCL/OFF with the limiter in standby
mode to switch the system off.
Endura (CDQ) New Zealand, enNZL, Edition date: 201712, First Printing
Driving Aids
Setting the Speed Limit
• Press Res+ with the limiter in standby
mode to set the limiter to the detected
speed limit. Speed limitation activates
and the Auto LIM symbol shows as
green.
• Press SET- with the limiter in standby
mode to set the limiter to the current
vehicle speed. Speed limitation
activates and the Auto LIM symbol
shows as green.
• Press RES+ or SET- to gradually
change the current set speed to your
desired speed limit. The speed is
displayed in the information display
and stored as the set speed.
• Press LIM CNCL/OFF to cancel the
limiter and place it in standby mode.
The Auto LIM symbol shows as grey.
• Press RES+ to resume the limiter. The
Auto LIM symbol shows as green.
• The limit speed will automatically
adapt to the speed limit detected by
the Traffic Sign Recognition system.
The Intelligent Speed Limiter will not
react to speed limits shown with a
supplementary sign by the Traffic Sign
Recognition system. If there is no speed
limit information available, the limiter
will switch to standby mode.
Intentionally Exceeding the Set Speed
Limit
Firmly depress the accelerator pedal to
temporarily turn the system off. The
system will reactivate once your vehicle
speed drops below the set speed.
System Warnings
If the set speed is automatically set to a
lower value than your current vehicle
speed, the set speed indicator in the
information display will flash and you will
hear an audible warning chime if you are
continuously exceeding the set speed.
176