Continue Scan - Revopoint 3D Technologies POP2 User Manual
Hide thumbs
Also See for POP2:
- User manual (33 pages) ,
- Quick start manual (32 pages) ,
- User manual (28 pages)
Table of Contents
Advertisement
POP 2 3D Scanner User Manual
Continue Scan
Continue Scan After Mesh
·
It is possible to continue scanning an object after the point cloud data has been meshed. This can be necessary if the scanning controller (a
computer or smartphone) runs out of RAM to capture more frames or if holes in the scan data are discovered. Don't forget to close the RGB
mode before continuing. This process can be repeated as needed until the model meets your requirements.
Open a model file
·
3D model files with defects can be fixed by continuing the scanning process:
:
to scan over holes:
COPYRIGHT ©2021 REVOPOINT 3D ALL RIGHTS RESERVED
20
Advertisement
Table of Contents
Need help?
Do you have a question about the POP2 and is the answer not in the manual?