Chapter 2 Observation Steps - Nikon ECLIPSE Ei Instructions Manual

Chapter 2 Observation Steps
2
Observation Steps
1
Install the microscope.
Carry the microscope from the storage location and
place it on a table.
Fix the direction of the eyepiece tube to the
observation point (the binoculars are toward you).
Loosen the fixing screw for the eyepiece tube a
couple of turns, and then turn the eyepiece
tube. → Chapter 4, "Assembly" - Step 2,
"Change the direction of the eyepiece tube,
remove and attach the eyepiece tube"
Pull out the AC adapter and power cord from the
storage part on the rear of the product.
2
Turn on the microscope.
Confirm that the DC plug of the AC adapter is
connected to the DC input connector on the rear of the
product, and plug the power cord of the AC adapter
into the wall outlet.
We recommend that you turn the brightness
control knob counterclockwise until it stops
before turning on the power. You might feel that
the illumination is too bright depending on the
position of the aperture diaphragm lever.
3
Turn on the light.
Check the status.
• Green LED: The light is on.
• Orange LED: The light is off.
If the LED is orange, press the light ON/OFF switch.
The LED turns green and the light is turned on.

Chapter 2 Observation Steps

Loosen the screw
a couple of turns
Lights up in green
46
Change the direction of the eyepiece tube.
Remove the AC adapter.
Turn on the microscope.
Turn on the light.