Advertisement
III. I/O Wire Connection
4
Double click the "EIP-2000 Utility" shortcut on the desktop.
1.
Click the "Network Scan" button to search your EIP-2000 modules(Figure 4-1).
2.
3.
Click the EIP-2019 or other EIP-2000 modules on the device list below to open the
configuration dialog of EIP-2000. Each EIP-2000 module has its own configuration
interface. Please refer to Figure 4-2.
(1) In the "Analog Input Status", users can select AI type of every channel.
(2) In the "AI Parameters", users can select the AI filters and AI representations here.
(3) In "CJC Settings Users" can set the CJC enable or not by the CJC Switch, and adjust
(4) If the network settings have been changed, please click the "Update Network
EIP-2019 Quick Start
Voltage Input
Using the EIP-2000 Utility
Figure 4-1 EIP-2000 Utility network scan
There are two different AI filters 50Hz and 60Hz. The selection of filters must
correspond with the frequency of AI sensors. Users have to check what are the
requirements of AI sensors. We provide two AI representations engineer and hex. If
users change the AI representation, all AI status will become to it.
CJC value with CJC Offset.
Settings" button to update the configuration and reboot the module.
Thermocouple Input
4
Advertisement
