Table of Contents
Advertisement
8 Appendix
8.1
Front End Detail
Figure 39.
8.2
Camera Command Overview
The TM-77X series Camera can be controlled via RS-232 communications. Commands are sent to the camera as
a string of ASCII characters. Each command begins with a start character of ":" and ends with the end
character CR (Decimal 10, hex D) which is indicated as <cr> in the following table. The camera will
acknowledge successful receipt and processing of the command with the response specified in the following
table. If, for any reason, the camera cannot recognize or process a command, it will respond with the Nack
response ":e"<cr>.
The camera will generate output only in response to an input command. Commands are not buffered. A new
command should not be sent until the camera has responded to the previous command. Any input to the
camera will be ignored until processing of the current command has completed and the camera response has
been output. Similarly, all characters received after the end character <cr>, but before the receipt of the
start character ":" will be ignored.
NOTE: The List of Camera Commands is fully comprehensive which includes commands for not only the TM-77X
series cameras, but also the TM-70X series, the TMC-77X series, and the AG-7000 cameras. Thus, not all
the commands listed are valid for TM-77X series cameras.
TM-77X Series
Front End Assembly
Appendix
45
Advertisement
Table of Contents
