Window Display - JAI TM-770 User Manual

8.3.95 Window Display

Function
Set Window Display State
Get Window Display State
8.3.96 Window Size Control (Obsolete in firmware 1.60 – replaced by WDS)
Note: This function has been replaced by the Window Display command (WDS) beginning in
firmware version 1.60.)
Function
Set Window Size
Get Window Size
8.3.97 WXN – Min ALC Window X Value
Function
Get ALC X Minimum
8.3.98 WYN – Min ALC Window Y Value
Function
Get ALC Y Minimum
TM-77X Series
Command String
:WDS=[D]<cr>
Turns the display of the window for ALC control on and off.
[D] is the state value. This command applies to camera
models TM-770, TMC-773, and TMC-775.
0 = ALC window display off.
1 = ALC window display on.
:WDS?<cr>
Enquire current state of the ALC Window display. [D] is the
current state. This command applies to camera models TM-
770, TMC-773, and TMC-775.
0 = ALC window display off.
1 = ALC window display on.
Command String
:WSZ=[D]<cr>
Set the window size for ALC control. [D] is the size parameter.
This command applies to camera models TM-770, TMC-773, and
TMC-775.
0 = Center window.
1 = Full window.
:WSZ?<cr>
Enquire current window size for ALC control. [D] is the current
size value. This command applies to camera models TM-770,
TMC-773, and TMC-775.
0 = Center window.
1 = Full window.
Command String
:WXN?<cr>
Enquire minimum allowable value for ALC window X coordinate
values. Different camera models may have a different value
range.
Command String
:WYN?<cr>
Enquire minimum allowable value for ALC window Y coordinate
values. Different camera models may have a different value
range.
Appendix
Camera Response
:o<cr>
:oWDS[D]<cr>
Camera Response
:o<cr>
:oWSZ[D]<cr>
Camera Response
:oWXN[DDD]<cr>
Camera Response
:oWYN[DDD]<cr>
77