Using The Tm-77X Software; The Main Screen; Figure 20. A Shortcut Provides Easy Access To The Tm-77X Software; Figure 21. Main Screen File Menu - JAI TM-770 User Manual

Figure 20.
4.2

Using the TM-77X Software

You must connect a camera via an RS-232 cable to the computer and power it up before starting the camera
control software.
Start the TM-77X software by clicking on the Start menu, and then selecting JAI_TM-77X and clicking the JAI
TM-77X shortcut on the right.
4.2.1

The Main Screen

The main screen offers several menus. Click on File in the menu bar to access the following:
Figure 21.
4.2.1.1 Preferences
Selecting Preferences opens a separate window that allows the user to set the COM port the camera will use to
interface with the computer. Set the port number by selecting it in the COM Port drop down list box. The
system defaults to the COM port number where the camera is attached.
In addition, this window allows you to rename the Control functions of "Zoom", "Focus", and "Iris". Thus, the
controls can be used for more general purpose functions, such as stepper motors for "Pan" and "Tilt".
Figure 22.
TM-77X Series
A shortcut provides easy access to the TM-77X software.
Main Screen File Menu
Set the COM Port
Software Introduction & Installation 27