Table of Contents
Advertisement
ADJ LED RC2 OPERATION
The ADJ LED RC2 infrared remote (sold seperately) has many different functions and provides com-
plete control of this fixture. The controller must be aimed at the front of the fixture, and the fixture's
infrared sensor must be switched on, as described in the Operating Instructions section of this
manual. Maximum range is 30 feet. Please note that the fixture will only respond to the remote when
the fixture is set to Secondary mode.
BLACKOUT - Pressing this button will blackout the fixture.
PROGRAM SELECTION - This button will let you access color change mode, color fade mode, auto
run mode, or static color mode. Each press of this button will scroll change to the next mode. Once
you have selected your desired mode, use the "+" or "-" to scroll through the programs or static colors.
When using the auto run, color fade, or color change, press the Speed button and use the "+" or "-" to
adjust the running speed.
•
If the Red LEDs flash, the fixture is in Color Fade Mode.
•
If the Green LEDs flash, the fixture is in Color Change Mode.
•
If the Blue LEDs flash, the fixture is in Auto Run Mode.
•
If the UV LED flashes, the fixture is in Static Color Mode.
FLASH - This button will activate the strobe effect. You can control the flash rate by pressing the "+"
and "-" buttons. Press this button again to exit strobe mode.
SPEED - Press this button, then use the "+" & "-" buttons to adjust the speed of the auto run, color
change, and color fade, or adjust the sound sensitivity in sound active mode.
DMX MODE - Pressing his button will scroll through DMX addressing, DMX Channel mode, DMX last
state setting, and dimmer curve mode. Some fixtures will come with different DMX channel modes.
When your desired menu/submenu is found, use the "+" & "-" buttons to scroll through the settings.
See the Operating Instructions and DMX Traits sections of this manual for detailed information.
SECONDARY/SA (SOUND ACTIVE) - Use this button to toggle between sound active mode and sec-
ondary mode. In sound active mode, use the "+" and "-" buttons to scroll through the 16 sound active
programs. Press the Speed button to and use the "+" and "-" buttons to adjust the sound sensitivity.
SET ADDRESS - Press this button to set the DMX address. Press this button first, then press the
numbers to set the address.
Example: To set DMX Address = 1, press "SET ADDRESS", then key in "0-0-1". Alternately, to set
DMX Address = 245, press "SET ADDRESS", then key in "2-4-5".
R G B A - Press any one of these buttons to select a color, then press the "+" or "-" to adjust the
brightness. "A" selects UV dimmer mode.
"+" and "-" - Use these buttons to adjust the flash rate, speed of the built-in programs, sound sensi-
tivity, and program selection.
14
Advertisement
Table of Contents
