ADJ MEGA GO PAR64 PLUS User Manual page 22

BATTERY STATUS AND RECHARGE
Battery Status:
This function is used to check the remaining battery life. Plug the fixture in and press the MODE but-
ton until "bXXX" is displayed. "XXX" represents an number between "000" and "100". The number
that is displayed is the remaining battery life percentage. If "b---" is displayed, it means the battery is
dead, or that the unit is running on AC power. Please do not let the battery die completely, as this
severly shortens the life of the battery.
Example: If "b050" is displayed, the battery is has half of its charge remaining. If "b025" is displayed,
the battery has 25% of its charge remaining.
NOTE: The digital display will flash when the battery is charging, or if the battery life is below 30%.
NOTE: After 20 seconds of inactivity, the display will revert back to the battery life display.
Battery Recharging: To recharge the battery, plug the supplied AC cord into the AC input on the side
of the unit, and plug the other end into a matching power supply. It takes about 4 hours for the battery
to reach full charge. The display will STOP flashing when the unit reaches 100% charge.
NOTE: When unplugging the unit from charging and then applying power via battery, there will be a
minimal charge drop.
For a faster recharge, put the Load Switch in the "Off" position and the Battery Switch in the "ON"
position.
22