ADJ MEGA GO PAR64 PLUS User Manual page 12

OPERATING INSTRUCTIONS
DMX State:
This mode determines how the unit will behave when the DMX signal is lost or interrupted. It can also
be used to select the operating mode that the unit will default to when powered on.
1. Plug the fixture in and press the MODE button until "d.XXX" is displayed. "XXX" represents the
currently selected DMX address.
2. Press the SET UP button so that "nodn" is displayed. Use the UP and DOWN buttons to scroll
through the DMX states.
• "bLAC" (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
• "LASt" (Last State) - If the DMX signal is lost or interrupted, the fixture will stay in the last DMX
set up.
• "ProG" (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into
Auto Run mode.
3. Press SET UP to select the option displayed and exit.
Dimmer Curve:
This is used to set the dimming curve used with DMX mode. See the Dimming Curves section of this
manual for detailed information.
1. Plug the fixture in and press the MODE button until "DMX MODE" is displayed.
2. Press the SET UP button until "dr-X" is displayed, where "X" represents the displayed dimmer
curve (0-4).
• 0 - Standard
• 1 - Stage
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select the desired dimming curve.
Activate IR Sensor:
This function is used to activate and deactivate the IR sensor. When this function is activated, you can
control the fixture using the ADJ LED RC2, UC IR, or Airstream IR App. Please refer to the ADJ LED
RC2 Control and UC IR & Airstream App Control sections of this manual for detailed information.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either "on"
or "oFF".
2. Press the SET UP button until "IrXX" is displayed. "XX" represents either "on" or "oF".
3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (Off).
Default Running Mode:
When this function is activated, all modes will return to their default settings.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either "on"
or "oFF".
2. Press the SET UP button until "dEFA" is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the MODE button to exit.
12