ADJ MEGA GO PAR64 PLUS User Manual page 10

OPERATING INSTRUCTIONS
System Menu: The display will lock after 30 seconds.To unlock, press and the MODE button
for 3 seconds.
LED Display On/Off:
To set the display press the MODE button until "dXX" is displayed. Use the UP or DOWN buttons to
select either:
• "don" = LED display on at all times.
• "doFF" = LED display shuts off after 10 seconds.
Please note, the display will turn off automatically after 10 seconds.
LED Display Inversion:
Follow these instructions to flip the display 180° so that the display can be read upside down.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either "on"
or "oFF".
2. Press the SET UP button until "Stnd" is displayed.
3. Press the UP or DOWN buttons to reverse the display 180°.
Operating Modes:
The Mega GO Par64 PLUS has five selectable operating modes:
• RGB+UV Dimmer Mode - Choose one of the four colors to remain static, or adjust the intensity of
each color to make a custom color.
• Sound-Active mode - The unit will react to sound, chasing through the built in programs. There are
16 sound active modes.
• Auto Run Mode - In Auto Run mode, you can choose 1 of 16 color change modes, 1 of 16 color
fade modes, or a combo color change & fade mode.
• Static Color Mode - There are 64 colors to choose from.
• DMX control mode - This function will allow you to control each individual fixtures traits with a
standard DMX 512 controller.
RGB+UV Dimmer Mode:
1. Plug the fixture in and press the MODE button until the desired option is shown:
• When "r.XXX" is displayed, the unit is in Red dimming mode. Press the UP and DOWN buttons
to adjust intensity.
• When "G.XXX" is displayed, the unit is in Green dimming mode. Press the UP and DOWN but-
tons to adjust intensity.
• When "b.XXX" is displayed, the unit is in Blue dimming mode. Press the UP and DOWN buttons
to adjust intensity.
• When "u.XXX" is displayed, the unit is in UV dimming mode. Press the UP and DOWN buttons
to adjust intensity.
2. After you have adjusted the RGB & UV colors to create your desired color, you can then activate
strobing by pressing the SET UP button to enter the Flash (strobe) mode.
3. "FS.XX" will be displayed, indicating that the unit is in Flash mode. The Flash can be adjusted
between "FS.00" (flash off) to "FS.15" (fastest flash).
10