Albatron KM333 Series User Manual page 41

Wake Up Control
If you highlight the "Wake Up Control" label and then press the enter key, it will display a
submenu with the following options:
PWRON After PWR-Fail
This option determines whether you want to restart the system after a power failure.
Select "On", to boot the system whether or not the system was on before power failure.
Choose Former-Sts, to restore the system to the status before the power failure.
Options: Off (default)、On
PS2KB Wakeup Select
Use this option to configure the PS2 keyboard Wake Up feature.
"Password" Use this selection to force the user to enter a password after the
system awakens from PS2 keyboard activity.
"Hot Key" Use PS2KB key to awake the system. See "PS2KB Wake Up from S3-S5" to
configure the hotkey.
PS2KB Wake Up from S3/S4/S5
This option is used when "PS2KB Wake Up Select" is configured as "HOT KEY".
Options: Disable (default)、Ctrl+F1(to F12)、Power、Wake、Anykey.
Power Button Lock
This item allows you to lock the power button. Options: Enabled、Disabled (default)
USB Wake Up
This item allows you to awaken the system upon receiving an incoming call to a USB
device. Options: Disabled (default)、Enabled
VGA
When set to "On", any event occurring at a VGA Port will awaken a system which had been
previously powered down. Options: OFF (default)、On.
LPT & COM
When this option is set to On, any event occurring at a COM(serial)/LPT (printer) port will
awaken a system which has been suspended. Options: LPT/COM (default)、COM、LPT、NONE
HDD & FDD
When set to "On", any event occurring on a hard drive activity or a floppy drive activity
will awaken the system which had been previously suspended. Options: ON (default)、OFF
37
KM333 Series