Albatron KM333 Series User Manual page 36

KM333 Series
Primary / Secondary /Master / Slave UDMA
Ultra DMA/133 functionality can be implemented if it is supported by the IDE hard drives
in your system. As well, your operating environment requires a DMA driver (Windows 95
OSR2 or a third party IDE bus master driver). If your hard drive and your system software
both support Ultra DMA/133, select "Auto" to enable BIOS support.
Options: Auto (default)、Disabled
IDE HDD Block Mode
Block mode is otherwise known as block transfer, multiple commands, or multiple sector
read/write. Select the "Enabled" option if your IDE hard drive supports block mode (most
new drives do). The system will automatically determine the optimal number of blocks
to read and write per sector. Options: Enabled (default)、Disabled
VIA OnChip PCI Device
If you highlight the "VIA OnChip PCI Device" label and then press the enter key, it will take
you a submenu with the following options:
AC'97 Audio
This option allows you to control the onboard AC'97 audio.
Options: Enabled (default)、Disabled
Onboard 1394 Device (only for KM333 PRO-1394)
This option allows you to control the onboard 1394 device.
Options: Enabled (default)、Disabled
Onboard LAN Device
This option allows you to control the onboard LAN device.
Options: Enabled (default)、Disabled
Onboard Lan Boot ROM
This item allows you to invoke the boot ROM of the onboard LAN chip.
Options: Disabled (default)、Enabled
USB Controller
This option should be enabled if your system has a USB port installed on the system
board. You will need to disable this feature if you add a higher performance controller.
Options: All Enabled (default)、All Disabled
OnChip EHCI Controller
This option should be enabled if your system has a USB 2.0 device installed on the system
board. You will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)、Disabled
32