Kernau KDI 4443 I User Manual page 58

FAULT
Partial food wastes
remain on the dishes
Whitish stains remains
on dishes
Dishes do not dry
Rust stains form on the
dishes
Detergent remains in the
detergent compartment
POSSIBLE CAUSE
Dishes placed incorrectly,
sprayed water not reaching
affected dishes
Dishes leaning each another
Not enough detergent used
Wrong wash programme
selected
Spray arms clogged with food
waste
Filters or water drain pump
clogged or filter misplaced
Not enough detergent used
Rinse aid dosage and/or water
softener setting set too low
High water hardness level
Salt compartment cap not closed
properly
Drying option is not selected
Rinse aid dosage set too low
Stainless-steel quality of the
dishes is insufficient
High level of salt in wash water
Salt compartment cap not closed
properly
Too much salt spilled in the
Dishwasher while filling it with
salt
A poor mains grounding
Detergent was added when the
detergent compartment was wet
58
TROUBLESHOOTING
Do not overload baskets
Place dishes as instructed in
the section on loading your
dishwasher
Use the correct amount of
detergent, as instructed in the
programme table
Use the information in the
programme table to select the
most appropriate programme
Clean the holes in the spray
arms with thin objects
Check the drain hose and filters
are correctly fitted
Use the correct amount of
detergent, as instructed in the
programme table
Increase rinse aid and/or water
softener level
Increase water softerner level
and add salt
Check that the salt compartment
cap is closed properly
Select a programme with a
drying option
Increase rinse aid dosage setting
Use only dishwasher-proof sets
Adjust the water hardness level
using water hardness table
Check that the salt compartment
cap is closed properly
Use funnel while filling salt
to the compartment to avoid
spillage
Consult a qualified electrician
immediately
Make sure detergent
compartment is dry before use