Chapter 2. Installation; Machine Positioning; Water Connection; Water Inlet Hose - Kernau KDI 4443 I User Manual

MACHINE POSITIONING

When positioning the machine, place it in an area where dishes can be easily loaded and unloaded. Do not
put the machine in an area where the ambient temperature falls below 0°C.Read all warnings located on the
packaging before removing the packaging and positioning the machine.Place the machine close to a water
tap and drain. Take into consideration that the connections will not be altered once the machine is in position.
Do not hold the machine by its door or panel. Leave an adequate distance around the machine to allow ease
of movement when cleaning.
RISK OD ELECTRIC SHOCK
Ensure the water inlet and outlet hoses are not squeezed or trapped and that the machine does
not stand on the electrical cable while positioning. Adjust the feet so the machine is level and
balanced. The machine should be placed on flat ground otherwise it will be unstable and the
door of the machine will not close properly.
CAUTION
Please install the decorative panel as indicated on the assembly sheet. Otherwise, the door may
not open properly and steam leakage problem may occur.

WATER CONNECTION

We recommend fitting a filter to your water inlet supply in order to prevent damage to your machine due
to contamination (sand, rust, etc.) from indoor plumbing. This will also help prevent yellowing and deposit
formation after washing. Note printing on the water inlet hose! If models are marked with 25°, the water
temperature may be max. 25 °C (cold water).
For all other models: Cold water preferred; hot water max. temperature 60 °C.

WATER INLET HOSE

WARNING
Use the new water inlet hose supplied with your machine, do not use an old machine's hose.

CHAPTER 2. INSTALLATION

38