VERSION 12/2018
10.3.2 ASSEMBLING THE VALVE ROD AND SPRAY GUN
1. Slide the sealing screw (F), sealing collar (G), thrust piece (H), the 6 spring washers (I)
and pressure ring (K) onto the valve rod (E).
Note:
The spring washers (I) have to be positioned reciprocally.
2. Insert the premounted valve rod into the gun housing.
3. When shifting the valve rod (E), screw in sealing screw (F) and carefully tighten until a
light resistance is noticeable.
4. Assembling of piston (D), pressure spring (B) and clamping nut (A) in the reverse order
in accordance with Chapter 10.3.1, steps 5 to 2.
SW 5
E
ORDER NUMBER DOC 350941
I
G
F
K
H
B_00870
GA 250AL_GA 400AL
I
G
H
K
36