N_RANGE (Nominal range of the sensor)
Command
N_RANGE_1:X
N_RANGE_2:X
N_RANGE (nominal range or nominal stroke) is used to define the length of the sensor. This value should be
always higher or equal in comparison with SYS_RANGE. The control parameter cannot be calculated cor-
rectly in case of wrong values.
OFFSET (Sensor zero correction)
Command
OFFSET_1:X
OFFSET_2:X
By these commands the zero-point of the axes can be adjusted.
The offset value is added to the control element signal at the output and limited to SYS_RANGE.
Page 28 of 70
Parameter
X
x= 10... 10000
X
Parameter
X
x= -100000...
100000
X
POS-124-U
Unit
Group
mm
INPUT
Unit
Group
µm
INPUT
24.01.2022