INSTRUCTION MANUAL DAAB AUTOMATIC CONTROLL UNIT EP104 4.08
Description of the EP104
• General
The EP104 is an automatic control unit for doors, gates, up-and-over doors and barriers, including all the components
necessary to control electric motors – contactors, motor protection, load guards, safety edges, alarm indications, buttons on
the PCB for operation and display, and a programming keypad.
The control unit can be supplied with accessories such as a vehicle loop, wireless functionality, signal lights and magnetic locks.
• Intended use
The purpose of the automatic control unit is to open and close doors, gates, up-and-over doors and barriers, using controllers
connected to the unit. No other use is permitted without the written agreement of FAAC Nordic AB.
• Identification
Output for software
upgrade.
Display
Data entry and
readout buttons
Indications
Control buttons
Terminal block
for low current
• Reference documentation
Instruction manual for motor winder
Instruction manual for the door, gate or barrier
• Disposal of electronic equipment
EP104 is an electronic product, and as such it is classified as hazardous waste. All used electronic equipment must be sent
!
for recycling by a company authorised under environmental legislation to handle hazardous waste including electronic
equipment.
FAAC Nordic AB will not charge to process used electronic products supplied by us, provided they are returned to us.
• Instruction manual
The installed control unit must be accompanied by this instruction manual or by an instruction manual that in every respect
meets the requirements in the applicable
Machine Directive and Low Voltage Directive and the relevant standardised norms, and must be provided to the
installer and the end user.
Instruction manual edition 1 for EP104 version 4.08
DB411
DB402 DB407
DB410
OPEN
STOP
CLOSE
X13
RE1
DB409
X4
TR1
RE2
X7
TR2
X11
X12
RE3
RE4
Indications
Motor contactors
EP104
MK10406
Terminal block
for high current
7