Programmable Input 2 - DAAB EP104 Instruction Manual

INSTRUCTION MANUAL DAAB AUTOMATIC CONTROLL UNIT EP104 4.08

Programmable input 2

No. Name
P200 Channels in programmable input 2
0 Disabled
1 Enabled
P260 Control function
0 Disabled
1 Open
2 Close
3 Stop
4 Open/close
5 Open/stop/close
P261 Type of control signal when activated
S
1 Pulse (hold-to-run mode not possible)
2 Signal for as long as the input is activated
P262 Half operation
1 Motor 1
2 Motor 2
3 Motors 1 and 2
P263 Limited opening
0 Disabled
1 Opening according to set time in channel C412/C414 or number of degrees in L116/L126 if encoder
is used.
P270 Motor lock
0 Disabled
1 The barrier cannot be operated without a signal at programmable input 2. If the signal disappears the
barrier is stopped.
P275 Opening via input after activation during set time,
input will not open the barrier until it has been
activated for the set time.
P280 Keep opened
0 Disabled
1 Automatic closing disabled after the input is activated, reset by another control signal
2 Automatic closing disabled by a constant signal
P290 Interlock opening
0 Disabled
1 Opens the local door if P260 is set to open, and passes the signal on to the remote door
P296 Blocking disabled for local and remote doors. Works
only with a constant signal.
0 Disabled
1 Active
P298 Automatic closing disabled for remote door Only
works if there is a constant signal
0 Disabled
1 Active
Instruction manual edition 1 for EP104 version 4.08
Range Factory Setting Ref.
0 - 1 1
0-5 2
1 - 2 1
1 - 3 3
0 - 1 0
0 - 1 0
0.0-9.9 seconds 0.0
0 - 2 0
0 - 1 0
0 - 1 0
0 - 1 0
page
31
31
31
31
31
31
31
31
31
31
31
47