Addressing; Dmx-Protocol - Future light PLB-15R User Manual

Wireless receiver sender status-LED
Red permanently lit: not logged into a wireless sender (free).
Red/green flashes rapidly: Login-mode, the wireless receiver is logging into the wireless sender.
Green permanently lit: The wireless receiver is logged into the wireless sender. The DMX-signal is present
and received.
Red/green flashes slowly: no DMX-signal, the radio link is being held.
The installation procedure of a wireless DMX system depends on the wireless sender. Please refer to
the user manual of the respective device.
Log out one wireless receiver
The projector is logged out via the Control Board, menu Personality - Wireless DMX – Clean WDMX Memo.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the PLB-15R will respond to the controller.
If you set, for example, in the 22 channel mode the address to channel 23, the PLB-15R will use the channel
23 to 44 for control.
Please, be sure that you don't have any overlapping channels in order to control each PLB-15R correctly and
independently from any other fixture on the DMX-chain.
If several PLB-15R are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the PLB-
15R via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the wireless receiver is not logged in to the wireless transmitter or no wireless DMX signal is received.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Mode/Channel Decimal
St Ba Ex
1 1 1
0
2 2 2
0
3 3 3
0
226 235
Hexad. Percentage S/F
255 00 FF 0% 100%
255 00 FF 0% 100%
225 00 E1 0% 88%
E2 EB 89% 92%
Horizontal movement (PAN) (within 630°)
F Push slider up in order to move the head horizontally
(PAN). Gradual head adjustment from one end of the
slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
Vertical movement (Tilt) (within 270°)
F Push slider up in order to move the head vertically
(TILT). Gradual head adjustment from one end of the
slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
PAN/TILT-speed
F Decreasing speed
S Blackout at PAN/TILT-movement
46/60
Feature
00072726, Version 1.0