Control Board - Future light PLB-15R User Manual

Control Board

The Control Board offers several features: you can simply set the starting address, switch on and off the
lamp, run the pre-programmed program or make a reset.
The main menu is accessed by pressing Mode/Esc until the display is lit. Browse through the menu by
pressing the arrow buttons (up, down, left, right). Press Enter in order to select the desired menu. You can
change the selection by pressing the arrow buttons. Press Enter in order to confirm. You can leave every
mode by pressing Mode/Esc. The functions provided are described in the following sections.
The fixture contains a battery-buffered Control Board that stores all settings and also allows the menu to be
accessed when the fixture is not connected to power. To access the display menu via the internal battery,
press and hold the ESDC button for two seconds, this will activate the menu. The display will automatically
switch off about one minute after the last pressing of the buttons.
Default settings shaded.
Main menu
Set DMX address
DMX value
Slave mode
Auto program
Sound control
Time information
Temperature info
Software version
Lamp on/off
Automatic on
Lamp on via DMX
Lamp off via DMX
Max on at temp.
Lamp off temp.
Status settings
Sub menu
001~ XXX
PAN ...
Slave 1, Slave 2, Slave 3
Master/Alone
Master/Alone
Current time
Total run time
Last run time
Lamp hours
Lamp off time
Last run password
Clean last run
Lamp time password
Clean lamp time
Head Temperature
V 1.0
ON/OFF
ON/OFF
ON/OFF
ON/OFF
20-79°C,45°C/68-174°F,113°F
80-139°C,130°C/176-282°F,266°F
Address via DMX
No DMX status
PAN reverse
TILT reverse
PAN degree
Feedback
Movement speed
Mic sensitivity
Hibernation
50/60
Display
XXXX (h)
XXXX (h)
XXXX (h)
XXXX (h)
XXXX (min)
Password=XXX
ON/OFF
Password=XXX
ON/OFF
XXX °C/°F
ON/OFF
Close/Hold/Auto/Music
ON/OFF
ON/OFF
630/540/540-90 offse
ON/OFF
Speed 1 ~ 4
0~99%
OFF/1-99M
Function
DMX address setting
DMX value display
Slave setting
Auto program
Music control
Power on running
time
Fixture running time
Individual fixture
running time
Lamp running time
Operating hours since
lamp off
Timer password code
= "180"
Clear fixture individ.
running time
Lamp password code
= "180"
Clear lamp time
Inside temperature
Software version of
each IC
Lamp on/off
Lamp on/off/ Power
Lamp on via DMX
Lamp off via DMX
Lamp restart at temp.
Lamp off at temp.
Addr. via DMX
Run if no DMX
Reverse movement
Select PAN-angle
630° or 540°
Automatic PAN/TILT
calibration
Adjust PAN/TILT
speed
Mic sensitivity
Standby mode
00072726, Version 1.0