Advertisement
September 2022
Note
Joining the device to the network could take several minutes.
Figure 4-2: Install Tool
4.1
Completing sensor installation
Complete the following steps in the installation application software on the
installation tab.
Procedure
1. Press the Start button and wait for an ultrasonic waveform to
download from the sensor.
Waveforms are automatically downloaded every 10 seconds. When a
new waveform arrives, the lines briefly become thicker.
Quick Start Guide
a) Verify that the sensor ID is displayed at the top of the screen
within 10 seconds.
b) Select the Provision tab.
c) Enter the 5-digit network ID and the 32-hexadecimal
(numbers 0-9 and letters A -F) join key.
d) Click the Provision button.
The system provides confirmation once provisioning is
complete.
e) Ensure the network ID of the gateway is visible in the Network
Discovery panel.
Quick Start Guide
15
Advertisement
