Installation And Configuration; Hardware Installation; Installing 2.5-Inch Solid-State Drives On 2.5-Inch Trays - QNAP TS-h 90FU Series User Manual

2. Installation and Configuration

This chapter provides specific hardware and firmware installation and configuration steps.

Hardware Installation

This section provides information on installing drives, memory modules, expansion cards, power supply
units, expansion units, handles, and rail kits.

Installing 2.5-inch Solid-state Drives on 2.5-inch Trays

Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
•
Moving fan blades: Keep your hands and other body parts away from moving fan
blades.
•
Other moving components: Keep your hands and other body parts away from other
moving components.
Note
The TS-h2490FU is compatible with 2.5-inch U.2 NVMe PCIe solid-state drives, and the
TS-h1090FU is compatible with 2.5-inch U.2 NVMe PCIe solid-state drives and SATA 6 Gbps
solid-state drives.
1. Power off the NAS.
2. Remove the drive tray.
a. Pull the handle to release the tray.
b. Pull the tray out.
TS-hx90FU User Guide
Installation and Configuration 17