Replacing Expansion Cards On The Ts-H2490Fu - QNAP TS-h 90FU Series User Manual

a. Log on to QuTS hero as administrator.
b. Go to Control Panel > System > System Status > Hardware Information .
c. Check the value for Total memory.

Replacing Expansion Cards on the TS-h2490FU

The TS-h2490FU supports selected expansion cards, some of which require QNAP PCIe brackets. QNAP-
branded expansion cards purchased from the company website are shipped with the brackets necessary to
fit the TS-h2490FU.
Warning
• Only qualified personnel should perform the following steps. Failure to follow
instructions can result in serious injury or death.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
•
Moving fan blades: Keep your hands and other body parts away from moving fan
blades.
•
Other moving components: Keep your hands and other body parts away from other
moving components.
Important
• Two dual-port 25GbE SFP28 network expansion cards are pre-installed in PCIe Gen 4.0
x8 slots 4 and 5 on the TS-h2490FU-7302P-128G.
• One dual-port 25GbE SFP28 network expansion card is pre-installed in PCIe Gen 4.0
x16 slot 5 on the TS-h2490FU-7232P-64G.
• Slot 2 will reduce its speed from x8 to x4 if an expansion card is installed in slot 3.
• Slot 5 will reduce its speed from x16 to x8 if an expansion card is installed in slot 4.
• For expansion card slot numbering, see
1. Power off the device.
2. Disconnect the power cord from the electrical outlet.
3. Disconnect all cables and external attachments.
4. Remove the case cover.
a. Loosen the screws.
System Board.
TS-hx90FU User Guide
Installation and Configuration 30