Reset Button; Leds - QNAP TS-h 90FU Series User Manual

Reset Button

Operation
Basic system reset
Advanced system
reset

LEDs

LEDs indicate the system status and related information when the device is powered on. The following
LED information applies only when the drive is correctly installed and when the device is connected to the
network or to a host.
Note
The 10 GbE LED only works when a 10 GbE network expansion card is installed.
For details on the location of the LEDs, see Components.
User Action
Press and hold the
button for 3 seconds.
Press and hold the
button for 15 seconds.
The following settings are reset to default:
• System administrator password: The default password
is the first MAC address in uppercase letters
without special characters. For example, if the first
MAC address is 00-08-9B-F6-15-75, then the admin
password will be 00089BF61575.
Note
You can find the first MAC address using
Qfinder Pro. A label attached to the device
also lists the address as MAC1.
• TCP/IP configuration:
• Obtain IP address settings automatically via DHCP
• Disable jumbo frames
• If port trunking is enabled (multi-LAN models
only), the port trunking mode is reset to "Active
Backup (Failover)".
• System port: 8080 (system service port)
• Security level: Low (Allow all connections)
• LCD panel password: (blank)
• VLAN: Disabled
The default factory settings are restored.
• To retrieve old data after an advanced system reset,
recreate the previous folder structure on the NAS.
TS-hx90FU User Guide
Result
Basic Operations 54