Settings - Counter; General; Fronius Smart Meter - Fronius Datamanager 2.0 Operating Instructions Manual

Settings – Counter

General

IMPORTANT! Settings in the "Counter" menu item may only be entered by staff
trained to do so!
The service password must be entered for the "Counter" menu item.
Three-phase or one-phase Fronius Smart Meters may be used. In both cases, se-
lection is made via the "Fronius Smart Meter" item. The Fronius Datamanager
automatically detects the counter type.
A primary meter or, optionally, multiple secondary meters can be chosen. The
primary meter must be configured before a secondary meter can be chosen.
Fronius Smart When the Fronius Smart Meter is chosen as a counter the field "Settings" must
Meter be used to set the counter position.
"Meter position" at "Feed-in point" (1a)
The power of feeding in and energy are measured. The consumption is determ-
ined using these values and the system data.
"Meter position" in "Consumption branch" (1b)
The consumed power and energy are measured directly. The power of feeding in
and energy are determined using these values and the system data.
Secondary meter
If a Fronius Smart Meter was chosen as a secondary meter, a window will open to
enter the "Description" (freely selectable) as well as a "Modbus address" field. A
value is suggested automatically in the "Modbus address" field (next free address
in the address range). The modbus address must not be assigned twice. Click on
"Scan" after entering.
(1a)
(1b)
79