Sending Service Messages Via A Dsl Internet Connection; Using Fronius Solar.web And Sending Service Messages - Fronius Datamanager 2.0 Operating Instructions Manual

Sending service messages
Connecting to Datamanager via Fronius Sol-
ar.web
Connecting to Datamanager via Fronius Sol-
ar.access or Fronius Solar.Service
Accessing the Datamanager website
Configure the firewall so that the IP address of Fronius system monitoring can
send data to port 49049/UDP from "fdmp.solarweb.com".
*) We recommend only allowing access to the web interface of the Fronius sys-
tem monitoring from a secure network. If access via the internet is absolutely ne-
cessary (e.g. for service purposes during a limited time period), configure the net-
work router so that requests for any external port are redirected to port 80/TCP.
Caution - this will make the inverter visible on the internet and more likely to be
subject to network attacks.
Sending Service Normally, no additional router configuration is required for a regular DSL inter-
Messages via a net connection to access Fronius Solar.web and/or send service messages, be-
DSL Internet cause connections from the LAN to the internet are open.
Connection
Using Fronius However, an internet connection is required to use Fronius Solar.web and send
Solar.web and service messages.
Sending Service
Messages Fronius Datamanager 2.0 cannot connect itself to the internet. A router must be
used for a DSL connection to the internet.
18
49049/UDP 80/TCP *)
output input
x -
x -
- x
- x